Filter
Top Products
36
4. POWER SUPPLY
2.
1.
1.
To use the NP-1 type battery, remove the Anton-Bauer Battery holder and attach the NP-1 type battery holder to the
camera. Use the following battery case.
Battery case: SCV2978-002
For details, please consult your JVC authorized dealer.
Detaching the Anton-Bauer Battery Holder and Attaching the Battery Case
1.
Remove the four battery holder anchoring screws.
2.
Disconnect the connector and battery holder connector
coming out of the camera.
Attaching and Detaching an Anton-Bauer Battery Pack
Attaching the Battery Pack
1.
Align the 3 guide pins of the battery pack with
the guide holes on the battery holder, and push
straight to insert the battery pack.
The battery cannot be attached properly if the
guide pins are not inserted straight.
2.
Slide the battery pack toward the side panel
where the cassette cover is located until it clicks.
Now the battery pack has been attached.
Detaching the Battery Pack
■While pushing the release lever, slide the battery
pack toward the side panel where the LCD display
is located, then pull the battery pack outward to
remove.
OPEN
CH-1
AUDIO INPUT
AUDIO SELECT
CH-2
CH-1 CH-2
FRONT
REAR
AUTO
MANUAL
AUDIO
LEVEL
CH-2
PULL
OPEN
LCDBRIGHT DISPLAY
Battery
Release lever
Anton-Bauer
Battery holder
Connector
Compartment
Guide pins
Battery pack
Release
lever
Cassette cover side panel
Guide holes
(x3)
Side panel
with display
4-2 Battery Pack Operation (Optional) (Cont’d)
3.
4.
Attaching the NP-1B type Battery
3.
Remove the two black screws A for the battery case.
4.
Remove the bottom portion of the battery case cover
downwards.
Black screws A
Be careful of pins.
The Anton-Bauer Battery Holder has pin connectors. Be
careful not to touch these pin terminals when attaching or
removing the battery and holder. Doing so may cause injury.
CAUTION:
4. POWER SUPPLY
E-36
Using a Flat Shape Type Battery Pack (optional)
Attaching a Flat Shape Type Battery Pack
Be sure to set the POWER switch to OFF before replacing
the battery pack.
1.
Open the battery case cover while pushing the lock release
lever.
2.
Insert the battery pack into the battery case with its
electrodes facing the unit.
3.
Close the battery case cover.
Lock release
lever
4-2 Battery Pack Operation (Optional) (Cont’d)
E
U