Filter
Top Products
KODAK Display Manager System V4.1 User’s Guide 25
Before Calibrating
Print Film Calibration Setup
The Print Film Calibration tab on the Setup window contains information that
is required to obtain an accurate print film match.
Projector Aim:
Projector aim values specify the intended film projector open gate settings.
Enter the values for the film projector you are emulating. If you have not
characterized a specific projector, use the default values.
• White Luminance (Y) - Open gate luminance can be measured by a
colorimeter or spectrophotometer. Enter the value in ft-lamberts.
• White Chromaticity (xy) - Open gate chromaticity can be measured by a
colorimeter or spectrophotometer. Enter values in CIE xy.
• Projector SPD (Spectral Power Distribution) - Click this button to open a
browse window where you can load a file that was created when
measuring your projector with a spectroradiometer. This file should be a
single column of values corresponding to measurements from
340
to 970 nm in 10 nm increments. Comment lines may be included in
the file preceded by a # sign.
•Select Projector Aim Luminance Adjust to bring the brightness of the
display down to the projector aim when simulating the print look. Deselect
this option to keep the brightness at the Display Aim.