Filter
Top Products
26 KODAK Display Manager System V4.1 User’s Guide
Before Calibrating
Display Aim:
Enter the desired White Luminance for the monitor in ft-lamberts. Setting
your monitor to the projector aim (typically 16 ft-lamberts) would make it too
dark for other work. The display aim gives you the opportunity to set a higher
display aim luminance.
Display - Automatic Calibration:
NOTE
The automatic calibration process tries to match all the values that you enter in
this section.
• From the Target drop-down list, select your monitor preset target that you
want to over-write during calibration.
• Set the Dark (code value). We recommend using the default settings.
• To override the projector Luminance and Chromaticity aim, check
Override Projector Aim for Dark Patch. The value fields become active
and you can enter new values for Dark Luminance (Y) and Dark
Chromaticity (x,y). We recommend using the default settings.
NOTE
The Use Print Film Calibration Settings checkbox is available in the Display
Manager System Print Film Edition. Select this checkbox to use the Print Film
target values in calibration.