VQT2G44
104
Advanced (Recording pictures)
[REC] mode:
Recording motion pictures with the desired
settings
( : Motion Picture P mode)
You can set the degree of peripheral defocus created by the exposure compensation or
the aperture setting and record motion pictures.
Set the mode dial to [ ].
Set the Focus Mode (P98)
Press the rear dial to change the settings screen.
A the exposure compensation
B the degree of peripheral defocus
• With each press of the rear dial, the camera switches between Exposure Compensation
and the degree of peripheral defocus setting operations.
• The degree of peripheral defocus guide disappears after approximately 4 seconds if no
operation is performed.
Rotate the rear dial to change the settings.
Press the motion picture button to start
the recording.
Stop the recording by pressing the motion
picture button again.
• If the card becomes full in the middle of recording, the camera stops recording
automatically.
• You can also start/stop motion picture recording by pressing the shutter button.
• Sound will go off when pressing the motion picture button or shutter button indicating
motion picture recording start/stop.
Sound volume can be set in [BEEP] (P34).
∫ About the flicker reduction function
The flicker reduction function can be switched [ON]/[OFF] by pressing the [‚].
• If there is marked flicker or striping when recording motion pictures under fluorescent lighting in
regions with a 50 Hz mains supply, set the Flicker Reduction Function to [ON]. The Flicker
Reduction Function will activate, automatically adjusting the shutter speed to 1/100. Note that
you cannot use PERIPHERAL DEFOCUS with the Flicker Reduction Function.
3 303 30
STDSTDSTD
AUTOAUTOAUTO
3 303 30
STDSTDSTD
AUTOAUTOAUTO
STDSTDSTD
3 303 30
AUTOAUTOAUTO
1m4040s
AWBAWBAWB
1m40s
1m4040s
AWBAWBAWB
1m40s
1m4040s
AWBAWBAWB
1m40s
AFSAFSAFS AFSAFSAFS AFSAFSAFS
3 30
3 30
AUTO
AUTO
AUTO
1m
40
40s
AWB
AWB
AWB
1m40s
AFS
AFS
AFS
STD
STD
STD
DMC-GF1KPP-VQT2G44_eng.book 104 ページ 2009年8月17日 月曜日 午後1時19分