Filter
Top Products
153
VQT2G44
Connecting to other equipment
Connect the camera to a PC via the USB connection cable A
(supplied).
• Do not use any other USB connection cables except the supplied one. Use of
cables other than the supplied USB connection cable may cause malfunction.
Press
3
/
4
to select [PC], and then press [MENU/SET].
• If [USB MODE] (P34) is set to [PC] in the [SETUP] menu in
advance, the camera will be automatically connected to the PC
without displaying the [USB MODE] selection screen. Since
there is no need to set this each time you connect to the PC, it
is convenient.
• When the camera has been connected to the PC with [USB MODE] set to
[PictBridge(PTP)], a message may appear on the PC’s screen. Select [Cancel] to close
the screen, and disconnect the camera from the PC. Then set [USB MODE] to [PC]
again.
Double-click on [Removable Disk] in [My Computer].
• When using a Macintosh, the drive is displayed on the desktop. (“LUMIX”, “NO_NAME”
or “Untitled” is displayed.)
Double-click [DCIM] folder.
Acquiring of still pictures and [MOTION JPEG] motion pictures
(other than [AVCHD Lite] motion pictures)
Preparations: Turn on the camera and the PC.
A USB connection cable (supplied)
• Check the directions of the connectors, and plug them straight in or unplug them straight out.
(Otherwise the connectors may be bent out of shape which may cause malfunction.)
B Align the marks, and insert.
C DC cable (DMW-DCC3; optional)
• Use a battery with sufficient battery power or the AC adaptor (P164). If the remaining battery
power becomes low while the camera and the PC are communicating, the status indicator
blinks and the alarm beeps.
Refer to
“Disconnecting the USB connection cable safely” (P154) before disconnecting the
USB connection cable. Otherwise, data may be destroyed.
USB MODE
SELECT
SET
PLEASE SELECT
THE USB MODE
MENU
PictBridge(PTP)
PC
DMC-GF1KPP-VQT2G44_eng.book 153 ページ ２００９年８月１７日 月曜日 午後１時１９分