Filter
Top Products
177
VQT2G44
Others
• Is the ISO sensitivity high or the shutter speed slow?
(ISO sensitivity is set to [AUTO] when the camera is shipped. Therefore, when taking pictures
indoors etc. noise will appear.)
> Decrease the ISO sensitivity. (P80)
> Increase the setting for [NOISE REDUCTION] in [FILM MODE] or lower the setting for each
of the items other than [NOISE REDUCTION]. (P82)
> Take pictures in bright places.
> Set the [LONG SHTR NR] to [ON]. (P119)
• If recording under fluorescent light, the brightness or the hue may change slightly when the
shutter speed becomes fast. This occurs due to the characteristics of fluorescent light. It is not
a malfunction.
• This is characteristic of MOS sensors which serve as the camera’s pickup sensors. It appears
when the subject has a bright part. Some unevenness may occur in the surrounding areas, but
this is not a malfunction.
It is recorded in motion pictures but is not recorded on still pictures.
• It is recommended that you take pictures while taking care not to expose the screen to sunlight
or any other source of strong light.
• This could be an inactive pixel. Perform the [PIXEL REFRESH] (P128) in the [CUSTOM
MENU].
• Are you in Exposure Compensation operation?
> Press the rear dial to switch to Exposure Compensation operation. (P65)
• Set the AF area to the distinctive color of the subject if there is a part that is different from the
surrounding color. (P72)
• It is recommended to use a card with SD Speed Class
¢
with “Class 6” or higher when recording
motion pictures.
¢ SD speed class is the speed standard regarding continuous writing.
• Depending on the type of the card, recording may stop in the middle.
> When you set the picture quality to [ ], [ ] or [ ], we recommend using a
high-speed card with “10MB/s” or greater displayed on the package.
The recorded picture looks rough.
Noise appears on the picture.
The brightness or the hue of the recorded picture is different from the actual
scene.
Reddish horizontal streaks appear on the LCD monitor during recording.
Bright spot not in subject is recorded.
You cannot compensate the exposure.
Subject cannot be locked.
(AF tracking not possible)
Motion pictures
Motion picture recording stops in the middle.
DMC-GF1KPP-VQT2G44_eng.book 177 ページ ２００９年８月１７日 月曜日 午後１時１９分