VQT2G44
164
Others
∫ About [LOCK] on the remote shutter
• You can keep the shutter button pressed fully. This is
effective when taking pictures with Burst Mode (P66) or
in [B] (Bulb) (P86).
• While pressing the shutter button fully, slide it to the
[LOCK] side.
• Slide it to the other side to cancel [LOCK].
Note
• Do not use any other remote shutters except DMW-RSL1 (optional).
• You cannot operate the camera with the remote shutter in the following cases.
– When the power save mode is canceled
• Record with Motion Picture P Mode (P104) when using for motion picture recording. Motion
picture recording can be started/stopped with the remote shutter.
Using the AC Adaptor
You can use the camera without worrying about battery discharge when it is connected to
a PC or a printer if you use the DC cable
(DMW-DCC3; optional) to connect the camera to
the battery charger/AC adaptor and connect the AC cable.
• Check that the camera is turned off.
• Close the flash.
Connect the AC cable.
Connect the DC cable A.
• Pull open the DC cable cover 1 and then
connect the DC cable to the camera body using
the same steps as “Inserting and Removing the
Card (optional)/the Battery” (P24). Pull the DC
cable through the opening as shown in the
illustration and then close the battery door 2.
• Be careful not to catch the DC cable
(DMW-DCC3; optional) when closing the battery
door.
• You cannot charge the battery if you connect the
DC cable.
Note
• Do not use any other AC cables except the supplied one.
• Do not use any other cables except a genuine Panasonic DC cable (DMW-DCC3; optional). If
you use other DC cables, it may cause a malfunction.
• The camera becomes warm during use. This is not a malfunction.
• Disconnect the charger/AC adaptor and DC cable when the camera is not in use.
DMC-GF1KPP-VQT2G44_eng.book 164 ページ ２００９年８月１７日 月曜日 午後１時１９分
