Filter
Top Products
45
VQT2G44
Basic
[REC] mode: ³
Taking pictures with your favorite settings
( : Program AE mode)
The camera automatically sets the shutter speed and the aperture value according to the
brightness of the subject.
You can take pictures with greater freedom by changing various settings in [REC] menu.
• Set the drive mode lever to [ ].
Set the mode dial to [ ].
A [AF/MF] button
• To change the setting while taking pictures, refer to
“Using the [REC] Mode Menu” (P114) or “Using
the [CUSTOM MENU]
” (P124).
Press [AF/MF] to set [AFS] or [AFC].
• Refer to
P46
for [AFS] and [AFC].
Press the shutter button halfway to focus.
• The focus indication (green) lights when the subject is
focused.
• The focus indication blinks when the subject is not
focused. In this case, a picture is not taken. Press the
shutter button halfway to focus on the subject again.
• The focus range is different depending on used lens.
– When 20 mm/F1.7 lens included in DMC-GF1C is
used: 20 cm (0.66 feet) to
¶
– When 14–45 mm/F3.5–5.6 lens included in
DMC-GF1K is used: 30 cm (0.99 feet) to
¶
• If the [SENSITIVITY] is set to [ISO100] and the aperture value is set to F1.7 (when
20 mm/F1.7 lens included in DMC-GF1C is attached) or the aperture value is set to
F3.5 (when 14–45 mm/F3.5–5.6 lens included in DMC-GF1K is attached), the shutter
speed is automatically set between about 30 seconds and 1/4000th of a second.
Press the halfway pressed shutter button
fully to take a picture.
• A picture is not taken until the subject is brought into focus.
• If you want to press the shutter button fully to take a picture even when the subject is
not focused, set [FOCUS PRIORITY] in the [CUSTOM MENU] menu to [OFF]. (P126)
• The access indication lights (P25) red when pictures are being recorded on the card.
DMC-GF1KPP-VQT2G44_eng.book 45 ページ ２００９年８月１７日 月曜日 午後１時１９分