Panasonic DMC-GF1C Digital Camera User Manual


 
VQT2G44
174
Others
[THIS CARD IS NOT FORMATTED WITH THIS CAMERA, AND NOT SUITABLE FOR
MOVIE RECORDING.]
The writing speed is lower if the card has been formatted using a PC or other equipment. As a
consequence, motion picture recording may stop in the middle. If this happens, make a
backup of the data and format (P36) the card in this unit.
[A FOLDER CANNOT BE CREATED]
A folder cannot be created because there are no remaining folder numbers that can be used.
(P154)
> Format the card after saving necessary data on a PC etc. (P36) If you execute
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P34)
[PICTURE IS DISPLAYED FOR 16:9 TV]/[PICTURE IS DISPLAYED FOR 4:3 TV]
The AV cable is connected to the camera.
> Press [MENU/SET] if you want to delete this message at once.
> Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P35)
This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P153,
155)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
The printer cannot print.
> Check the printer.
[NO BATTERY POWER REMAINS]
The remaining battery power is low.
> Charge the battery.
[THIS BATTERY CANNOT BE USED]
The battery cannot be recognized by the camera.
> Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Center.
The battery cannot be recognized as its terminal is dirty.
> Remove any dirt etc. from the terminal.
DMC-GF1KPP-VQT2G44_eng.book 174 ページ 2009年8月17日 月曜日 午後1時19分