Filter
Top Products
173
8
Using the Bluetooth
®
Function
1
Check that the destination device is turned on.
2
Turn the mode dial to 5/K and shoot the picture.
3
Press the Q (Quick Review) button.
• A screen appears confirming whether to send the image.
4
Press the MENU/OK button.
• When the Bluetooth
®
function is used
for the first time, a screen appears
confirming whether to search for a
destination device.
• If you have already searched for a
destination device, a list of destination
devices appears. Go to Step 6.
• If the camera is connected using a
serial connection, a screen appears confirming whether to disconnect
the serial connection. Select [YES] and press the MENU/OK button
and go to Step 6.
• If the camera is connected using a wireless LAN connection, a screen
appears confirming whether to disconnect the wireless LAN
connection. Select [YES] and press the MENU/OK button, and go to
Step 5 or Step 6. (Only for Caplio 500SE-W)
5
Press the $ button to select
[YES] and then press the
MENU/OK button.
• The camera begins searching for a
destination device and a list of
destination devices appears when the
search is completed.
• By default, up to five devices can be
discovered, but you can change this to
search for any number of devices between one and ten. (GP.176)
6
Press the !" buttons to select
the desired destination device.
• If the desired destination device is not
listed, press the ADJ. button to search
again for destination devices.
• Select a destination device and press
the $ button to display information
about the destination device.
• To delete a destination device from the
list, select the device and press the D (Delete) button.
When [QUICK SEND MODE] is set to [2TOUCH]