Ricoh 500SE Digital Camera User Manual


 
222
11
Appendices
Bluetooth
®
related error messages
Error Message Cause and Action Refer to
REQUESTED FILE CANNOT
PRINT.
You attempted to send an image other than still ones (.JPG).
Only still images (.JPG) can be sent.
P.154
REQUESTED FILE CANNOT BE
SENT.
You attempted to send an image other than still ones (.JPG).
Only still images (.JPG) can be sent.
P.154
VERIFYING FAILED. The input passkey did not match the destination device.
Enter the correct passkey.
-
The passkey was not entered within the time limit. Enter the
passkey again within the time limit.
P.162
CANNOT CONNECT. At the start of transfer, the destination device could not be
connected due to one of the following causes. Check the
device status and start again from the beginning.
Signal no longer reach the destination device.
The destination device does not exist nearby (about
10 m).
The destination device is not active because the power is
off or due to other causes.
The destination device does not support the Bluetooth
®
Profiles required for communication with this camera.
Inappropriate device was selected for the destination.
P.154
PRINTING FAILED. Printing failed during transfer due to one of the causes
below. Check the device status and start again from the
beginning.
Signal no longer reach the destination device.
The destination device is not ready to print.
There is insufficient space on the destination device.
-
CANNOT SEND. Transfer was interrupted by one of the following causes.
Check the device status and start again from the beginning.
Signal no longer reach the destination device.
The destination device can no longer receive a signal.
There is insufficient space on the destination device.
-