Filter
Top Products
183
Appendices
20
20 Appendices
Troubleshooting
Error Messages
If an error message is displayed on the screen, check the information
on the reference page and take the corresponding action.
Non-Bluetooth® or Wireless LAN related error messages
Error Message Cause and Solution Refer to
Insert card. No card is loaded. Insert a card. P.29
Set date. The date is not set. Set the date. P.100
The file number limit has
been exceeded.
The file number limit has been exceeded. Use another card. P.100
Unmatched File This file cannot be displayed on the camera. Check the file contents
on your computer, and then delete the file.
—
Insufficient memory.
Continue?
All the files cannot be copied because there is insufficient memory
on the card. Use another card.
P.25
Protected The file selected for deletion is protected. P.91
Card Is Write-Protected. The card is locked (write-protected). Unlock the card. P.27
This option is not available
with SD WORM cards.
Selected option is not available with SD WORM or Write Once cards.
Use a different type of card.
P.25
Print settings cannot be
applied to this file.
This file (movie or other file) cannot be selected for printing. —
Insufficient Memory/
Capacity Short
Files cannot be stored. Make sure there is sufficient memory or
delete unwanted files.
P.43,
P.96
The image print number limit has been exceeded. Select an image
and set the number to 0.
P.173
Format internal memory. The internal memory requires formatting. P.96
Format card. The card is not formatted. Format the card with this camera. P.96
Card Error Reformat the card. If the error message still appears after that, the
card may be faulty. Do not use the card.
P.96
Writing Data Writing file to memory. Wait until writing finishes. —
No File There are no files that can be played back. —
Out of memory. cannot
record.
The number of remaining shots is 0. Switch to another card or the
internal memory.
P.25
No files to restore. There are no files to restore. P.86
Can not —. * Selected option can not be applied to image more than once, or
image was created with different make of camera. If image was
created with different make of camera, process image using original
make of camera.
—
* “—“ indicates the name of the process that can not be applied.