Filter
Top Products
184
Appendices
20
Bluetooth® related error messages
Error Message Cause and Solution Refer to
Requested file cannot
be sent.
You attempted to send an image other than still ones (.JPG). Only
still images (.JPG) can be sent.
P.130
Verifying failed. The input passkey did not match the destination device. Enter the
correct passkey.
—
The passkey was not entered within the time limit. Enter the
passkey again within the time limit.
P.131
Cannot connect. At the start of transfer, the destination device could not be
connected due to one of the following causes. Check the device
status and start again from the beginning.
• Signal no longer reach the destination device.
• The destination device does not exist nearby (about 10 m
(3.3 ft.)).
• The destination device is not active because the power is off or
due to other causes.
• The destination device does not support the Bluetooth® Profiles
required for communication with this camera.
• Inappropriate device was selected for the destination.
• The storage space available on the destination device is
insufficient.
P.130
Cannot send. Transfer was interrupted by one of the following causes. Check the
device status and start again from the beginning.
• Signal no longer reach the destination device.
• The destination device can no longer receive a signal.
• There is insufficient space on the destination device.
—
Service for selected
device not supported.
The camera was unable to connect to the destination device for any
of the following reasons. Check the device and repeat the operation.
• The device is off.
• The device is on but Bluetooth is not enabled.
• Bluetooth is enabled but the operation was performed
immediately after the device was turned on.
• The device does not support the camera Bluetooth profile.
—