Filter
Top Products
Security Escort | Technical Reference Manual | 3.0 System Menus
and Screens
EN | 21
Bosch Security Systems | 6/12 | 38947D
A third number, the point number is
unique to a particular device. Point
numbers range from 0 to 63. There is a
one-to-one correspondence between a
point number and a point multiplex
address/bus number pair. The point
number assignment is presented in a
table displayed whenever the ? box to
the right of the Point Number field is
clicked.
Figure 11 illustrates a quick way to
select a particular device without
having to translate between the two
numbering systems. Three buttons at the
bottom of this screen allow the user to
display all possible device numbers
(whether or not the particular
transponder has a device assigned to
the number) or, to display only
locations populated by receivers or
only locations populated by alert
units.
When the Point Number button in the
table is clicked, the Point Number
table disappears and that point number
automatically appears in the Point
Number field of the Transponder
Database Screen. The bus number and
point address are also changed to
reflect the selection
Figure 11: Select Point Screen with
"Receivers Only" Selected
+, -, Bus + and Bus -
These buttons, just below the Point
Number field, allow you to quickly
advance the device selection by one
location, either one point location (+
or -) or one bus number (Bus + or Bus -
). This is useful when a task requires
proceeding from device to device, as
during system setup or check out. The ?
box is used to display all devices to
facilitate quick selection of a
particular device. It is most useful
when diagnosing a problem with a
particular device.
Point Type
The Point Type field indicates the type
of device (receiver, virtual receiver,
or alert unit) located at the location
currently selected in the Point Number
field. Once the Point Number field
contains the proper value, the device
type is set by selecting from the
options in the drop-down menu that
appears when the arrow to the right of
the Point Type field is clicked.
Figure 12: Drop-Down Menu for
Selection of Point Type