Filter
Top Products
Security Escort | Technical Reference Manual | 3.0 System Menus
and Screens
EN | 45
Bosch Security Systems | 6/12 | 38947D
Off
When clicked, the checked horn-siren,
green LED and strobe-red LED outputs
are turned off for the selected point
on the selected transponder. If the
output does not change, click On Output
Command and click Off again.
On Output Command
When clicked, the checked horn-siren,
green LED, and strobe-red LED outputs
are turned on for the selected point on
the selected transponder. If the output
does not change, click Off and then
click On Output Command again.
Transponder
Selects the transponder you desire to
communicate with.
Previous
Returns to the previous transponder.
Next
Advances to the next transponder.
Bus X Point Y
This field displays the current bus
number and point number. The actual
point number may be entered in the
field to the right.
?
Opens up the Select Point Screen.
+
Advances to the next point.
-
Returns to the previous point.
Unlimited Retries
When this box is checked, the central
console continues trying to send
commands to a transponder even if the
commands are not being acknowledged.
(Normally, the central console would
cease after six retries and declare a
communication failure.) When this
screen is closed, the system reverts to
the normal six retries.
3.3.10 Transponder Current Status
Screen
This screen, accessible from the Main
Menu under the Setup selection,
provides a history of communications
involving the transponder selected in
the transponder box. It also provides
several buttons, that can be used to
diagnose problems with the transponder
and any of its receivers or alert
units.
Figure 433: Transponder Current
Status Screen
Transponder
Selects the transponder you want to see
the status of.
Total Alarms Received
The total number of alarm messages
received by the central console from
this transponder since the data was
last reset (using the Reset Transponder
Troubles button).
Total Tests Received
The total number of test messages
received by the central console from
this transponder since the data was
last reset (using the Reset Transponder
Troubles button).
Total Troubles Processed
The total number of trouble messages
received by the central console from
the transponder and processed (see
Total Troubles Shed) since the data was
last reset (using the Reset Transponder
Troubles button).
Total Troubles Shed
During certain rare occurrences, the
communication traffic on the
transponder links becomes excessive and
threatens to increase the system
response time to tests and alarms. This
can happen if faults are reported at a
very high rate. To avoid slow response
in such situations, the central console
may go into a load shedding mode in
which it ceases to record and display
Trouble Reports until the
communications traffic subsides. The
Total Troubles Shed box indicates the
number of trouble messages that were
not processed since the last reset
(using Reset Transponder Troubles
button).