Filter
Top Products
Security Escort | Technical Reference Manual | 6.0 Security Escort
Pager Setup
EN | 74
Bosch Security Systems | 6/12 | 38947D
6.3 Service and Security (Alarm)
Pager Setup
Pager access is setup in the Pager
Setup Screen under the Setup Menu.
Refer to the Pager Setup Screen for the
details not covered here.
Figure 733: Pager Setup Screen
For both the service and security
pagers, an individual pager (phone
number, password, and pager ID) can be
assigned. The pager ID is required for
all individual pagers, dial-up and
local. If the phone number and password
are assigned, the page is sent over the
modem connection. If the phone number
and password fields are both blank, the
page is routed to the local paging
system. If you do not desire an
individual pager, leave the phone
number, password, and pager ID fields
blank.
Both the service and security pagers
also support paging groups. If a group
number is programmed in the pager group
field, all the members of that group
are paged for every service or alarm
page.
If service or alarm pages are enabled,
either the paging group or individual
pager must be filled in. They may both
be filled in if desired.
The baud rate assignments in this
screen affect only the dial-up paging
access through the modem (get the
desired baud rate from the paging
company). These baud rate selections
have no effect on local paging systems
or remote system access. Remember that
dial-up pages may be routed to
different paging companies and they may
require different baud rates. Set the
baud rate to the highest baud rate
common to all of the paging companies
to be accessed.
The character limit (characters per
page), pages per call affect all pages
of the indicated type (local and dial-
up). These fields must be set to the
lowest setting for any of the routes
that may be used. Remember that dial-up
pages may be routed to different paging
companies and they may have different
restrictions.
6.4 Subscriber (Individual)
Pager Setup
In the Subscriber Database, select the
record for the desired individual.
Press Edit data then press Advanced.
The screen displays.
The pager ID is required for all
individual pagers dial-up and local. If
the phone number and password are
assigned, the page is sent over the
modem connection. If the phone number
and password fields are blank, the page
is routed to the local paging system.
If you do not desire this individual to
have pager support, leave the phone
number, password, and pager ID fields
blank.
Figure 744: Subscriber Database
Advanced Screen