Filter
Top Products
Security Escort | Technical Reference Manual | 3.0 System Menus
and Screens
EN | 62
Bosch Security Systems | 6/12 | 38947D
Access Password
This is the password used to gain
access to the remote Security Escort
System. On the live system being dialed
into, set the remote password in the
Remote Setup Screen. If the first five
characters of the password match, the
remote system allows read only access.
If all twelve characters match, you can
change system parameters remotely.
Verify Password
For verification, retype the password
entered into Access Password.
3 Character System ID
Enter a unique three character ID that
is used as an extension to the map and
database files for accessing this
Security Escort System.
3.3.23 Pager Setup Screen
This screen sets up remote pager access
for troubles (service) and alarms
(security).
Figure 588: Pager Setup Screen
Automatically Send Selected Troubles
If checked, send the troubles selected
in the pop-up Trouble Filter Screen to
the service pager.
Phone Number
Phone number to be dialed to access the
paging service. This phone number is
usually different from the number you
manually dial to send a page. The
paging company assigns this value.
Password
This is the password that must be sent
to the paging service to send the page.
If not required, leave this field
blank. Usually a password is not
required. The paging company assigns
this value.
Pager ID
This is the ID that identifies the
specific pager this message is to be
sent to. Many times it is the last
seven digits of the phone number you
would manually dial to access this
pager. The paging company assigns this
value.
Character Limit
This is the maximum number of
characters allowed per page. Typically,
this is set to 80 characters. The
Security Escort System truncates the
pager message at this number of
characters. The paging company assigns
this value.
Pages Per Call
This is the maximum number of pager
messages allowed per phone call.
Typically, this is set to four pages
per call. When this number of messages
is sent and there are more messages to
be delivered, the Security Escort
System hangs up and redials the paging
service to deliver the remaining
messages. The paging company assigns
this value.
Pager Group
This is the group of up to eight pagers
this message is sent to. You can
program the individual pager as well as
a group of pagers. The pager group is
sent the page before the individual.
Baud Rate
This is the baud rate used to
communicate with the paging computers.
The paging company assigns this value.
System Name
This identifies the Security Escort
System when multiple Security Escort
Systems report to the same service
pager. Keep this field as short as
possible since these characters, plus a
space, are sent before each trouble
message and are included in the
character limit. If not desired, leave
blank.
System Phone
This presents phone numbers to call in
response to the service page. Only use
if required since these characters,
plus a space, are sent before each
trouble message. They are included with
the system name in the character limit.
If not desired, leave blank.