Filter
Top Products
Security Escort | Technical Reference Manual | 3.0 System Menus
and Screens
EN | 39
Bosch Security Systems | 6/12 | 38947D
Point Troubles
Outputs all reported receiver and alert
unit troubles. This item is checked for
devices used to monitor problems.
Login Changes
Reports all new system operator login
and logout activity.
Network Communications
Records all communications between
networked computers. This selection is
only used for engineering diagnostics.
Leaving this item selected generates a
significant amount of history and fills
up the hard disk drive very quickly and
may bog down the system during high
traffic times. Always leave this item
unchecked.
Modem Communications
Records all communications to the modem
for remote communications and pager
access. This selection is only used for
diagnosing pager communication
problems. Leave this item unchecked.
Analyze Alarms
This option outputs data allowing an
engineer to evaluate how well the
location algorithm is performing. Leave
this item unchecked.
Master Computer Switch
Records when the master and slave
computers switch roles.
Transponder Data View
Allows the data created by the
Transponder Data View Screen to be
output. This selection is only used for
engineering diagnostics. Leave this
item unchecked.
Printer Output
Allows the data being sent to the
printer to be sent to other outputs.
This item is unchecked.
3.3.3 Popup Trouble Filter
The Security Escort System contains
many built-in self testing features.
Each transponder tests the condition of
the receivers and alert units connected
to it.
When the transponder finds a device
reporting a trouble condition, it
communicates the problem and the device
identity to the central console. This
generates a brief alert tone, displays
a pop-up message for the operator, and
sends an optional pager message. The
message indicates the nature of the
trouble and instructs the operator on
the proper course of action. The status
of the device is recorded in the
Transponder Current Status (See Section
3.3.10 Transponder Current Status
Screen) file under the Setup Menu. The
event is recorded on the hard disks of
both the main and backup computers and
on the printout.
Figure 40: Pop-Up Alert Showing
Receiver not Responding
Selects which trouble categories cause
pop-up messages to appear on the
central console or be sent to the
service pager. The troubles described
below are always recorded in the
Transponder Current Status Screen, but
might or might not produce a pop-up
display or pager message, depending on
the selections made.
Figure 411: Pop-up Trouble Filter
Screen