Filter
Top Products
VOT-320 Installation | en 17
Bosch Sicherheitssysteme GmbH Installation and Operating Manual DOC | V4.5 | 2010.09
4 Installation
4.1 Preparations
Please ensure the following installation conditions:
– Do not install the unit close to heat sources. Avoid locations exposed to direct sunlight.
– Allow sufficient space for running cables.
– Ensure that the unit has adequate ventilation.
– When making connections, use only the cables supplied or use appropriate cables
immune to electromagnetic interference.
– Ensure to use cables matching the installation location. For example, use cables marked
“Outdoor Cable” or “Water Resistant” for outdoor installation. For the US, cables must
comply with NATIONAL ELECTRICAL CODE, NFPA 70.
– Position and run all cables so that they are protected from damage, and provide
adequate cable strain relief where needed.
– Avoid impacts, blows and severe vibrations that exceed the specification limits (see
Section 9 Specifications, page 104), as these can irreparably damage the unit.
4.2 Mounting
You can mount the camera to mounts or pan/tilts and place it to walls, below ceilings, on roof
tops or poles or any other load-bearing locations.
CAUTION!
The camera is intended for indoor and outdoor use.
Select a suitable location for installation that guarantees to meet the environmental
conditions. The ambient temperature must be between -50 and +55 °C (-58 and +131 °F). The
relative humidity must not exceed 93%.
CAUTION!
The camera must be properly and securely mounted to a supporting structure capable of
sustaining the unit weight. Use care when selecting mounts or pan/tilts (not supplied) for
installation; the mounting surface and unit's weight should be carefully considered.
CAUTION!
If the camera is mounted to a pan/tilt, ensure that your hands do not get caught or crushed
between camera and pan/tilt.