Filter
Top Products
18 en | Installation VOT-320
DOC | V4.5 | 2010.09 Installation and Operating Manual Bosch Sicherheitssysteme GmbH
1. Use two appropriate screws, washers and spring washers to mount the camera to a
mount or a pan/tilt. The spring washers must be used for the screws to thread properly.
2. Open the cover by unlatching the three latches on the side of the housing.
3. Choose the appropriate cable glands. The following cable glands are provided:
– 1 × NPT 3/8’’ for cable diameters from 4 to 8 mm
– 1 × NPT 3/8’’ for cable diameters from 2 to 6 mm
– 2 × NPT 1/2’’ for cable diameters from 6 to 12 mm
The identical cable glands are for the outer two openings in the housing. For the middle
opening, choose the NPT 3/8’’ cable gland with the correct diameter for your cabeling to
prevent water from entering.
4. Fasten the required cable glands. Tighten the glands to a torque of at least 1.6 Nm.
5. Run the required cables through the cable glands and close the glands.
CAUTION!
Always securely tighten all cable glands to ensure a liquid-tight seal. Failure to do so could
allow water to enter the housing and damage the camera module and electronic parts. If a
sealant is used, be sure it is a neutral cure type. Sealants that release acetic acid may harm
camera electronics. Use of drip loops is recommended on the wiring outside of the rear end
cap.