Filter
Top Products
VOT-320 Configuration using a Web browser | en 71
Bosch Sicherheitssysteme GmbH Installation and Operating Manual DOC | V4.5 | 2010.09
HTTPS browser port
If you wish to allow browser access on the network via a secure connection, select an HTTPS
browser port from the list if necessary. The default HTTPS port is 443. Select the Off option
to deactivate HTTPS ports; only unsecured connections will now be possible.
The VOT-320 uses the TLS 1.0 encryption protocol. You may have to activate this protocol via
your browser configuration. You must also activate the protocol for the Java applications (via
the Java control panel in the Windows control panel).
You can activate and configure encryption of the media data (video and metadata) on the
Encryption page (see Section 5.38 Advanced Mode: Encryption, page 77).
RCP+ port 1756
To exchange connection data, you can activate the unsecured RCP+ port 1756. If you want
connection data to be transmitted only when encrypted, select the Off option to deactivate
the port.
Telnet support
If you want to allow only secure connections with encrypted data transmission, you must
select the Off option to deactivate Telnet support. The camera will then no longer be
accessible using the Telnet protocol.
Interface mode ETH
If necessary, select the Ethernet link type for the Ethernet interface. Depending on the unit
connected, it may be necessary to select a special operation type.
Network MSS [Byte]
You can set the maximum segment size for the IP packet's user data. This gives you the option
to adjust the size of the data packets to the network environment and to optimize data
transmission. Please comply with the MTU value of 1,514 bytes in UDP mode.
iSCSI MSS [Byte]
You can specify a higher MSS value for a connection to the iSCSI system than for the other
data traffic via the network. The potential value depends on the network structure. A higher
value is only useful if the iSCSI system is located in the same subnet as the VOT-320.
Enable DynDNS
DynDNS.org is a DNS hosting service that stores IP addresses in a database ready for use. It
allows you to select the VOT-320 via the Internet using a host name, without having to know
the current IP address of the camera. You can enable this service here. To do this, you must
have an account with DynDNS.org and you must have registered the required host name for
the camera on that site.
Host name
Enter the host name registered on DynDNS.org for the VOT-320 here.
NOTICE!
If you want to allow only secure connections with SSL encryption, you must select the Off
option for each of the parameters HTTP browser port, RCP+ port 1756 and Telnet support.
This deactivates all unsecured connections. Connections will then only be possible via the
HTTPS port.
NOTICE!
Information about the service, registration process and available host names can be found at
DynDNS.org.