Filter
Top Products
VOT-320 Configuration using a Web browser | en 73
Bosch Sicherheitssysteme GmbH Installation and Operating Manual DOC | V4.5 | 2010.09
5.35 Advanced Mode: Advanced
The settings on this page are used to implement advanced settings for the network.
Some changes only take effect after the camera is rebooted. In this case, the Set button
changes to Set and Reboot.
1. Make the desired changes.
2. Click the Set and Reboot button. The VOT-320 is rebooted and the changed settings are
activated.
SNMP
The VOT-320 supports the SNMP V2 (Simple Network Management Protocol) for managing
and monitoring network components, and can send SNMP messages (traps) to IP addresses.
The camera supports SNMP MIB II in the unified code. If you wish to send SNMP traps, enter
the IP addresses of one or two required target devices here.
If you select On for the SNMP parameter and do not enter an SNMP host address, the
VOT-320 does not send the SNMP traps automatically, but only replies to SNMP requests. If
you enter one or two SNMP host addresses, SNMP traps are sent automatically. Select Off to
deactivate the SNMP function.