Filter
Top Products
VOT-320 Appendix | en 97
Bosch Sicherheitssysteme GmbH Installation and Operating Manual DOC | V4.5 | 2010.09
8.3 Malfunctions with iSCSI connections
8.4 LEDs
The VOT-320 has LEDs on its camera module that show the operating status and can give
indications of possible malfunctions (see Section 3.4 Controls and displays on the camera
module, page 15):
CONNECT (opening A)
LINK and ACT (opening B)
LED group D (opening D)
Malfunction Possible causes Recommended solution
After connecting to the
iSCSI target, no LUNs are
displayed.
Incorrect LUN mapping during
iSCSI system configuration.
Check the iSCSI system
configuration and reconnect.
After connecting to the
iSCSI target, "LUN FAIL"
appears below a node.
The LUN list could not be read,
as it was assigned to the wrong
network interface.
Check the iSCSI system
configuration and reconnect.
LUN mapping is not
possible.
Some iSCSI systems do not
support the use of an initiator
extension.
Delete the initiator extension on
the Identification configuration
page.
Does not light up: VOT-320 is switched off.
Lights up green: VOT-320 is running.
Lights up red: Startup in progress.
Flashes green: Video transmission.
Flashes red: Firmware upload failed.
Green LED lights up: Link: Network connection established.
Orange LED lights up: Activity: Data transmission via network connection.
UP (red): Pan/tilt is moving up.
LEFT (red): Pan/tilt is moving left.
RIGHT (red): Pan/tilt is moving right.
DOWN (red): Pan/tilt is moving down.
WND (red): Window heater is switched on.
HTR (red): Printed circuit board heating is switched on.
PWR (orange): VOT-320 is switched on.