Filter
Top Products
30 en | Configuration using a Web browser VOT-320
DOC | V4.5 | 2010.09 Installation and Operating Manual Bosch Sicherheitssysteme GmbH
5.5 Basic Mode: Network
The settings on this page are used to integrate the VOT-320 into an existing network.
Some changes only take effect after the camera is rebooted. In this case, the Set button
changes to Set and Reboot.
1. Make the desired changes.
2. Click the Set and Reboot button. The VOT-320 is rebooted and the changed settings are
activated.
DHCP
If a DHCP server is employed in the network for the dynamic assignment of IP addresses, you
can activate acceptance of IP addresses automatically assigned to the VOT-320.
Certain applications (Bosch Video Client, Bosch Video Management System) use the IP
address for the unique assignment of the camera. If you use these applications, the DHCP
server must support the fixed assignment between IP address and MAC address, and must be
appropriately set up so that, once an IP address is assigned, it is retained each time the
system is rebooted.
IP address
Enter the desired IP address for the VOT-320 in this field. The IP address must be valid for the
network.
Subnet mask
Enter the appropriate subnet mask for the selected IP address here.
Gateway address
If you want the camera to establish a connection to a remote location in a different subnet,
enter the IP address of the gateway here. Otherwise leave the box blank (0.0.0.0).
CAUTION!
If you change the IP address, subnet mask or gateway address, the VOT-320 is only available
under the new addresses after the reboot.