Filter
Top Products
90 en | Operation VOT-320
DOC | V4.5 | 2010.09 Installation and Operating Manual Bosch Sicherheitssysteme GmbH
Bookmarks
In addition, you can set markers in the sequences, so-called bookmarks, and leap directly to
these. These bookmarks are indicated as small yellow arrows above the time interval. Use the
bookmarks as follows:
6.7 Hardware connections between video servers
A VOT-320 can be used as a sender and a compatible hardware decoder (such as the VIP XD)
with a connected monitor as a receiver using an Ethernet network connection. In this way it is
possible to cover long distances without the need for major installation or cabling work.
Installation
Compatible video servers are designed to connect to one another automatically, provided
they are correctly configured. They only need to be part of a closed network. Proceed as
follows to install the units:
1. Connect the units to the closed network using Ethernet cables.
2. Connect them to the power supply.
Connecting
There are three options for establishing a connection between a sender and a compatible
receiver in a closed network:
– an alarm,
– a terminal program, or
–Internet Explorer.
Jump to the previous bookmark
Set bookmark
Jump to the following bookmark
NOTICE!
Bookmarks are only valid while you are in the RECORDINGS page; they are not saved with the
sequences. As soon as you leave the page all bookmarks are deleted.
NOTICE!
The sender and receiver must be located in the same subnet to establish a hardware
connection.
NOTICE!
Make sure that the units are configured for the network environment and that the correct IP
address for the remote location to be contacted in the event of an alarm is set on the Alarm
Connections configuration page (see Section 5.24 Advanced Mode: Alarm Connections,
page 53).