Filter
Top Products
VOT-320 Configuration using a Web browser | en 29
Bosch Sicherheitssysteme GmbH Installation and Operating Manual DOC | V4.5 | 2010.09
Confirm password
In each case, enter the new password a second time to eliminate typing mistakes.
5.4 Basic Mode: Date/Time
Device date / Device time / Device time zone
If there are multiple devices operating in your system or network, it is important to
synchronize their internal clocks. For example, it is only possible to identify and correctly
evaluate simultaneous recordings when all units are operating on the same time. If necessary,
you can synchronize the camera with your computer's system settings.
Click the Sync to PC button to copy your computer's system time to the VOT-320.
Time server IP address
The VOT-320 can receive the time signal from a time server using various time server
protocols, and then use it to set the internal clock. The camera polls the time signal
automatically once every minute.
Enter the IP address of a time server here.
Time server type
Select the protocol that is supported by the selected time server. Preferably, you should
select SNTP server as the protocol. This supports a high level of accuracy and is required for
special applications and subsequent function extensions.
Select Time server for a time server that works with the protocol RFC 868.
NOTICE!
Proper password protection is only guaranteed when all higher authorization levels are also
protected with a password. If a live password is assigned, for example, a service and a user
password must also be set. When assigning passwords, you should therefore always start
from the highest authorization level, service, and use different passwords.