Filter
Top Products
54 en | Configuration using a Web browser VOT-320
DOC | V4.5 | 2010.09 Installation and Operating Manual Bosch Sicherheitssysteme GmbH
Connect on alarm
Select On so that the VOT-320 automatically connects to a predefined IP address in the event
of an alarm.
By setting Follows input 1 the camera maintains the connection that has been automatically
established for as long as an alarm exists on alarm input 1.
Number of destination IP address
Specify the numbers of the IP addresses to be contacted in the event of an alarm. The camera
contacts the remote stations one after the other in the numbered sequence until a connection
is made.
Destination IP address
For each number, enter the corresponding IP address for the desired remote station.
Destination password
If the remote station is password protected, enter the password here.
In this page, you can save a maximum of ten destination IP addresses and hence up to ten
passwords for connecting to remote stations. If connections to more than ten remote stations
are to be possible, for example when initiating connections via higher-ranking systems such as
Bosch Video Client or Bosch Video Management System, you can store a general password
here. The VOT-320 can use this general password to connect to all remote stations protected
with the same password. In this case, proceed as follows:
1. In the Number of destination IP address list field, select 10.
2. Enter the address 0.0.0.0 in the Destination IP address field.
3. Enter your chosen password in the Destination password field.
4. Define this password as the user password for all remote stations to which a connection
is to be possible.
Video transmission
If the camera is operated behind a firewall, TCP (HTTP port) should be selected as the
transfer protocol. For use in a local network, select UDP.
Stream
Select the stream for transmission in case of an alarm.
NOTICE!
In the default setting, Stream 1 is transmitted for alarm connections. Bear this fact in mind
when assigning the profile (see Section 5.17 Advanced Mode: Encoder Profile, page 40).
NOTICE!
If you enter the destination IP address 0.0.0.0 for destination 10, the VOT-320 will no longer
use this address for the tenth attempt at automatic connection in the event of an alarm. The
parameter is then used only to save the general password.
CAUTION!
Please note that in some circumstances, a larger bandwidth must be available on the network
for additional video images in the event of an alarm, in case multicast operation is not
possible. To enable multicast operation, select the UDP option for the Video transmission
parameter here and on the Network page (see Section Video transmission, page 70).