Filter
Top Products
6
FIGURE 2-2. Pipe Mounting
MODEL 54e pH/ORP SECTION 2.0
INSTALLATION
FIGURE 2-3. Panel Mounting
2.3.4 Panel Mounting:
The controller is designed to fit into a 5.43 x 5.43 inch (DIN standard 137.9 x137.9 mm) panel cutout (Figure 2-3).
Installation requires both front and rear access.
1. Install the controller as shown in Figure 2-3. Insert the instrument enclosure through the front of the panel
cutout and align the panel mounting brackets as shown.
2. Insert two mounting bracket screws through each of the two mounting brackets and into the tapped holes in
the rear of the controller enclosure and tighten each screw.
3. Insert four panel mounting screws through each hole in the mounting brackets. Tighten each screw until the
mounting bracket holds controller firmly in place. To avoid damaging the controller mounting brackets, do not
use excessive force.