Filter
Top Products
74
MODEL 54e pH/ORP APPENDIX A
ORP CONFIGURATION
FIGURE A-1. Outline of Menu Levels for ORP
PRESS TWO ARROWS
bb
and then ENTER
PRESS ENTER
PRESS
ARROWS
bb
PRESS
ARROWS
bb
PRESS
ENTER
Calibrate
Diagnostic variables
Program
Exit Enter
Alarm setpoints
Output setpoints
Simulated tests
Exit Enter
Simulated tests
Configure
Exit Enter
Display
Outputs
Alarms
Exit More Enter
CALIBRATE MENU SEC-
TION
Buffer Calibration 4.2, 4.3
Standardize pH 4.4
Adjust Temperature 4.1
Temp Compensation4.5
pH slope 4.6
CONFIGURE MENU SEC-
TION
Display 5.5
Outputs 5.6
Alarms 5.7
Diagnostics 5.8
Security 7.1
PROGRAM MENU
SEC
TION
Alarm setpoints 5.1
Output setpoints (PID)5.2
Output setpoints 5.3
Simulated tests 5.4
Diagnostics
Security
Exit More Enter
Standardize
Adjust temperature
Exit Enter
Accessing Calibrate, Program and Configure
Menus. Operating configuration changes are made at
the levels shown in Figure A-1. Press any key from
the main display to access the main menu (top left).
Refer to Section 5 for pH measurements.
Level 1 Calibrate. To access calibration selections
from the main menu, with the cursor on "Calibrate"
press Enter (F4). ORP standardization and tempera-
ture adjustments are made at this level (refer to
Section A.1 and Section 3.1 for these procedures).
Level 2 Program. To access the program level from
the main menu, place the cursor over "Program" with
the down arrow key. Then press Enter (F4). From the
program level menu, changes can be made to the
alarm setpoints and the output setpoints.
Level 3 Configure. To access the configure level
from the main menu place cursor over "Program" and
Enter (F4) then place cursor over "Configure" and
Enter (F4). This level contains advanced selections,
such as alarms and diagnostics.