Filter
Top Products
MODEL 54e pH/ORP SECTION 5.0
SOFTWARE CONFIGURATION
Accessing Calibrate, Program and Configure Menus.
Operating configuration changes are made at the levels
shown in Figure 5-1. Pressing any key from the main dis-
play will access the main menu (top left). Refer to
Appendix A for ORP measurements.
Level 1 Calibrate. To access calibration selections from
the main menu, with the cursor on "Calibrate" press Enter
(F4). All buffer calibration, pH standardization and tem-
perature adjustments are made at this level (refer to
Section 4.0 for these procedures).
Level 2 Program. To access the program level from the
main menu, place the cursor over "Program" with the
down arrow key. Then press Enter (F4). From the program
level menu, changes can be made to the alarm setpoints
and the output setpoints.
Level 3 Configure. To access the configure level from the
main menu place cursor over "Program" and Enter (F4),
then place cursor over "Configure" and Enter (F4). This
level contains advanced selections, such as alarms, diag-
nostics, autocal and others.
25
FIGURE 5-1. Outline of Menu Levels
Blank
Out 2
R1
GI
In
AL2
AL3