Filter
Top Products
4. Press the button to increase the number, or the
button to decrease the number, until the item
you want to adjust is correct.
5. Repeat steps 3 and 4 until the date and time are
correctly adjusted and saved. Press the
SELECT
button or
BACK
button to return to the Settings
menu.
Note:
You need to reset the time and date whenever you replace the
camera’s batteries. In this case, you can enter the clock setting
mode directly rather than going through the Settings menu.
See page 20 for instructions.
Setting the alert beep
To turn the camera’s alert beep on or off, follow
these steps:
1. With the Settings menu selected, press the
SELECT
button. Icons for each setting appear on the screen,
with the clock icon highlighted in orange.
2. Press the button to select the beep setting icon ;
then press the
SELECT
button to select
ON
or
OFF
.
The current selection is highlighted.
3. Press the
BACK
button to save your setting and return
to the Settings menu.
Setting LCD brightness
To adjust the brightness of the LCD screen, follow
the steps below:
1. With the Settings menu selected, press the
SELECT
button. Icons for each setting appear on the screen,
with the clock icon highlighted in orange.
2. Press thebutton until the brightness icon is
highlighted in orange, then press the
SELECT
button
again. The mark on the brightness setting slide bar
turns orange.
3. Slide the mark on the bar by press the and
buttons to adjust the screen brightness.
4. Press the
SELECT
or
BACK
button to save your setting
and return to the Settings menu.
4
R
Poppy Rev.B/TCAT
A5 size Chapter 4
97/09/18 pass 3
Using the LCD Monitor Menus
61