Filter
Top Products
111
Ⅵ
Auto Trace
This item stores and reproduces manual operation.
Note:
●
As Auto Trace performs simple saving of manual operation, the position may be shifted
during playback.
●
Digital Flip cannot be used during Auto Trace recording. .
A
State
[Record Start] : The camera will start recording of Pan/Tilt and Zoom
operations. (for approximately 30 seconds)
[Record Stop] : Click this when a recording operation is complete.
M
emo:
●
For details on the manual operation, see [PTZ Control] (
A
Page 113).
[State] Display
The current status is displayed.
Standby : The camera is on standby. [Record Stop] is invalid.
Recording : The camera is recording. Click [Record Stop] to finish
recording. ACompletedB will be displayed.
Completed : Recording is completed. After ACompletedB is displayed
for 3 seconds, AStandbyB will be displayed.
Timeout : 30 seconds has passed since recording started.
(Operation for the 30 seconds has been recorded.) After
ATimeoutB is displayed for 3 seconds, AStandbyB will be
displayed.
Memory Full : The operation has exceeded the number of recordable
operations. Further recording cannot be made even if it is
within 30 seconds. (Operations before the limit are
recorded.)) After AMemory FullB is displayed for 3 seconds,
AStandbyB will be displayed.
B
Pan /Tilt /Zoom
Ⅵ
Pan/Tilt operation
Click the arrow buttons to move the display area in the direction indicated by the arrow.
Release the button to stop the movement.
Click the [H] button to move to the home position.
Ⅵ
Zoom operation
Use this function to perform zoom operation on the display area.
[+] : Zoom is set to TELE and the object becomes bigger.
[-] : Zoom is set to WIDE and the object becomes smaller.
Ⅵ
Ratio to Full Area
Shows current ratio to full area.
M
emo:
●
You can restrict the magnification of the object using the [+] button by altering the
[Zoom Limit] settings. (
A
Page 69)
C
Speed
This item sets the operation speed.
Pan/Tilt : This item sets the operation speed of the [Pan/Tilt] operation
button.Increase the number to increase the operation speed.
[Setting range:1 to 8]
Zoom : This item sets the operation speed of the [Zoom] operation
button.Increase the number to increase the operation speed.
[Setting range: 1 to 4]