Filter
Top Products
28
Connection/Installation (VN-V686WPBU)
Mounting the Camera
1
Mount the fall prevention wire
●
Mount the fall prevention wire of the camera to the fall
prevention wire anchor bolt that was installed earlier.
●
Secure the fall prevention wire tightly with a nut and
washer.
2
Pull out the cables (from the wall) from the
cable connection hole.
3
Mount the camera to the wall
●
Mount the camera to the camera anchor bolts that
were installed earlier.
●
Secure the camera tightly with a nut and washer.
Note:
●
This product weighs approximately 5.5k
g
. When
installing, pay extra attention as it may fall.
●
For your safety, hold the arm section during
installation.
●
After installing, paint the nuts and washers to prevent
corrosion.
M
emo:
●
To remove the camera, follow the reverse procedures.
Cable Connection
1 Connecting the power cable
(A Page 30)
Connect the power cable and wind the
waterproof tape (adhesive).
After connecting, push the cable into the arm of
the camera.
2 LAN Cable Connection (A Page 31)
A Use the provided RJ-45 conversion connector
and connect the LAN cable.
B Wind the connector section with waterproof
tape (adhesive) and push the cable into the
arm of the camera.
Mounting the Camera
(continued)
1
2
3
Fall Prevention
Wire
Washer
Nut
Wind the waterproof tape (adhesive)
Arm
B
A
Wind the
waterproof tape
(adhesive)
Arm
RJ-45
conversion
connector
(provided)