Filter
Top Products
65
B FTP (continued) Setting the Periodic FTP Time Filter:
For specifying the periodic FTP transfer action with respect to each day of
the week and setting the corresponding time of the day.
Applicable day of week
:Sunday, Monday, Tuesday, Wednesday, Thursday, Friday,
Saturday
Alarm action : Mask span
Unmask span
Mask All
Unmask All
Applicable time period: For specifying the Start and End time in hours and
minutes.
Pre-/Post-recording parameter:
[PrePostRecording Frame Rate]
: For specifying the JPEG frame rate for FTP pre-/post-
recording.
[Setting value:1 fps, 2 fps, 3 fps, 5 fps, 6 fps, 7.5 fps,
10 fps, 15 fps, 30 fps]
[PrePostRecording Before Trigger]
: For setting the FTP pre-recording trigger time (recording
time before alarm input) in seconds.
[Setting value:0sec to 60sec]
[PrePostRecording After Trigger]
: For setting the FTP post-recording trigger time (recording
time after alarm input) in seconds.
[Setting value:0sec to 60sec]
The maximum time intervals for [PrePostRecording Before Trigger] and
[PrePostRecording After Trigger] are determined by the JPEG size on the
Encoding page as well as [PrePostRecording Frame Rate]. A message
appears if the combination of the entered values are not feasible.
C Alarm Output For setting the alarm output.
Duration For setting the output time of [Manual Output].
[Setting range:0 / 100 msec to 5000 msec]
Manual Output For operating alarm output manually.
The current output status appears on the right. When [Duration] is set to A0B,
pressing the [Make] button switches the alarm to Make output, while
pressing the [Break] button switches the alarm to Break output.
When [Duration] is set to a value other than A0B, pressing the [Make] button
switches the alarm to Make output only during the duration of the output,
upon which it switches to Break output.
When the output duration is set to a value other than A0B, pressing the
[Break] button switches the alarm to Break output only during the duration of
the output, upon which it switches to Make output.