Filter
Top Products
81
Protocol Page
This page is for changing the HTTP server port number.
This page can be used during access using AadminB.
● Click [Advanced Settings] to display setting menu.
● Click [Protocol]. Press the [OK] button to enable the new settings.
● Press the [OK] button to enable the new settings.
● After changing, you will need to re-establish the connection if you are using the Internet Explorer.
M
emo:
● If Built-in Viewer is used for playback, change the [HTTP Port] number in the setting screen of Built-
in Viewer to the same value. (A Page 119)(A Page 121)
A
B
C
D
Click
A HTTP Server
Port
You can change the port number for the built-in web server of the camera.
(1-65535)
The default port number setting is A 80B. The port number of JPEG/MPEG4
server is changed also.
To access to camera from the Internet Explorer, enter the following in the
Internet Explorer when the camera is in its default settings.
http://192.168.0.2
If the port number is changed to A8080B, for example, enter the Internet
Explorer as follows.
http://192.168.0.2:8080
B VISIP Protocol You can change the On/Off setting of VSIP Protocol. To use this unit from
Nextiva of Verint Systems Inc., select AOnB.
C HTTP Server
Port
You can change the port number for Built-in VSIP server of the camera.
(1-65535) The default port number setting is A5510B.
D AMX Device
Discovery
Protocol
You can change the On/Off setting of AMX device detection protocol. Set to
AOnB when you are using the camera on AMX’s systems.
[Setting value:On , Off]