Filter
Top Products
118
Operation
JPEG Viewer Settings (continued)
Built-in Viewer (continued)
ⅥStream For specifying settings for receiving JPEG stream.
A Stream For selecting the protocol when the viewer acquires data from the
camera.
When AHTTPB is selected, lost packets are recovered via resending.
Camera may be monitored using multiple viewers when AMulticastB is
selected. When playing back via multicast, start multicast sending on the
[Streaming] page.
[Streaming Page] (A Page 82)
Note:
● When Built-in Viewer is launched with AMulticastB specified, a
Windows firewall warning may appear. In this case, select AunblockB
and proceed.
● If AblockB is selected, the Windows firewall will block the multicast
stream and playback of AMulticastB by the viewer will fail.
B HTTP Port You can change the HTTP port number.
The default port number setting is A80B.
Specify the same value as the parameter that is set on the [Protocol]
page of the camera. (A Page 81)
C Frame Rate For selecting the acquisition frame rate of the viewer.
Selecting a large frame rate will increase the processing load of the
computer on which the viewer is running.
[Setting values:30, 25, 15, 10, 7.5, 6, 5, 3, 2, 1, 1/2, 1/3, 1/5, 1/10, 1/15,
1/20, 1/30, 1/60]
Note:
● Set to a rate such that the CPU burden of the computer does not
exceed 80 %. If the CPU is overloaded, the computer may not
function properly.
D Multicast IP
Address
You can change the multicast IP address.
The default IP address setting is A225.0.1.1B.
E Multicast Port You can change the multicast port number.
The default port number setting is A49152B.
M
emo:
● This is enabled when [Start] is selected for the[JPEG] [Control] item
on the [Streaming] page.
● Specify the same value as the parameter that is set on the
[Streaming] page of the camera. (A Page 82)
Other
A Folder Name For specifying the name of the folder in which the captured files are
stored. (When the viewer is installed: AVN-V685B(VN-V685U),AVN-
V686BB(VN-V686BU/VN-V686WPBU)