Filter
Top Products
183
9
Troubleshooting
1 The power is off.
2 The batteries are loaded
incorrectly.
3 The batteries are exhausted.
4 The batteries are temporarily
unable to function.
5 It is connected to a personal
computer.
1 Press the POWER switch to turn
on the power.
2 Reload the batteries correctly.
3 Replace the batteries with new
ones
.
4 Keep the batteries warm while
using the camera.
5 The camera will not operate while
it is connected to a personal
computer.
P. 28
P. 23
P. 23
P. 164
POSSIBLE CAUSES CORRECTIVE ACTION
REF. PAGE
The camera does not work.
The viewfinder does not turn on.
1 The camera is in the Sleep
mode.
2 The camera is in the
playback mode.
1 Operate the camera (press the
Shutter button, turn the Mode dial,
etc.)
2 Set the Mode dial to any position
except .
P. 34
P. 47
The monitor does not turn on.
1 The Monitor is in the Sleep
mode.
2 The camera is in the sleep
mode.
3 The camera is in the battery
save mode.
1 Operate the camera (press the
Shutter button, turn the Mode dial,
etc.)
2 Operate the camera (press the
Shutter button, turn the Mode dial,
etc.)
3 Set BATTERY SAVE to OFF in
the Menu.
P. 34
P. 34, 37
P. 129
No picture is taken when the Shutter button is pressed.
1 The Mode dial is set to
.
2 The memory gauge is full.
3 The flash has not finished
charging.
4 The card access lamp blinks
after shooting in the
mode.
1 Set the Mode dial to any position
except .
2 Wait until there is room in the
memory gauge.
3 Remove your finger from the
Shutter button and wait until the
flash charge mark stops blinking.
Take your shot again.
4 The recorded movie image data is
being written to the card. You can
start shooting again when the
card access lamp stops blinking.
P. 47
P. 15
P. 78
P. 41