Filter
Top Products
23
1
Loading the batteries
This camera uses 2 CR-V3 lithium battery packs or 4 AA (R6) NiMH batteries, NiCd
batteries or lithium batteries.
Important:
Do not peel the label on a CR-V3 lithium battery pack. If an insulating sheet covers
the terminals, peel it off ONLY from the terminals.
Load the batteries as shown below:
Slide the battery
compartment lock on the
battery compartment
cover in the direction of
.
Slide the battery
compartment cover in the
direction of T printed on
it with your fingertip.
Using a fingernail could
result in injury.
Insert the batteries in the direction
shown in the illustration.
When using
lithium battery
packs
When using AA
(R6) batteries
1
Close the battery compartment cover,
then press it down and slide it in the
opposite direction of the arrow printed on
it.
● When pressing the battery compartment
cover shut, be sure to press the center of
the cover, as it may be difficult to close
properly by pressing the edge.
● Make sure the cover is completely closed.
2
4
3
5
6
7
~
Continued on next page
Make sure the camera is
turned off (i.e. the
monitor and viewfinder
are off, and the lens is
not locked into place).