Filter
Top Products
Set the Mode dial to the position shown in the
illustration. In this example, you would set .
20
How to use this reference manual
The instructions in this manual use a series of numbers for each operating procedure
and button/dial illustration. Operate the camera in the order of these numbers.
Means “Press this button”.
Press to save setting/selection.
Press Ññ on the Arrow
pad to select an item.
Erasing pictures
Ⅵ Check the following before erasing pictures.
● Make sure the card is not write-protected. If it is, remove the write-protect seal.
● NEVER open the card cover, eject the card, remove the batteries, or pull out the
plug when the card access lamp is blinking during picture erasure. Doing so may
destroy data stored on the card.
Set the Mode dial to
.
1
The card access lamp blinks and stored pictures
areread out. After that, the last recorded picture
appears. Select the picture you want to erase.
2
Displays the next picture.
Jumps to the picture 10
frames ahead.
Displays the previous
picture.
Jumps to the picture10 frames behind.
HQ
’01.12.23. 21:56 24
Press the (erase)
button.
3
When the ERASE
screen asking you to
confirm the erasure
appears, press Ñ to
select YES.
4
Press to erase the
picture.
5
ERASE
YES
N O
SELECTSELECT GOGO
Ⅵ To cancel erasure
Press ñ on the Arrow pad to select NO, and press or the button.
The selected setting
is framed in green.
If a button turns black, this
means you should press it
as part of the step.
Ñ, ñ, É and í used in
instructions correspond
to the buttons on the
Arrow pad as shown.
Ñ
ñ
É
í
The buttons used in the
instruction are displayed at
the bottom of the screen
illustration.