Filter
Top Products
37
2
●How to shoot using the monitor
T Press the (monitor) button.
T If the camera is not used for more than 30
seconds, the monitor turns off. If you use
the shutter button or zoom lever, the
monitor turns on again.
●There is no display in the viewfinder.
T Is the power on (P. 28)?
T Has the lens cap been removed (P. 32)?
T Is the camera in the sleep mode (P. 28, 127)?
T Is the monitor turned on with the Mode dial set to ?
T If the remaining battery power is close to zero, the viewfinder turns off
automatically and the flash begins charging. During charging, the card access
lamp blinks. When charging finishes, the viewfinder turns on and you can
shoot again.
●Shooting is not possible.
T If the memory is full and the memory gauge lights all the way, you cannot take
any more pictures. When the top of the memory gauge is partially or
completely empty, you can take another shot.
T If the AF confirmation mark blinks, remove your finger from the Shutter button
and press it again.
T If CARD FULL appears in the monitor, there is no space on the card. Delete
the pictures (P. 39), replace with a new card (P. 26) or transfer pictures to a
computer (P. 164–170).
TIPS
(monitor) button
●Press the shutter button gently using the ball of your finger. If it is pressed hard, the
camera may move and pictures may come out blurred.
●Recorded pictures will be saved in the card regardless of whether the camera is
turned off or the batteries are replaced or removed.
●NEVER open the card cover, eject the card, remove the batteries, or pull the plug
when the card access lamp is blinking. Doing so could destroy stored pictures and
prevent storage of pictures you have just taken.
Note:
Taking still pictures (Cont.)