Filter
Top Products
106
Chapter 7 Menu description tables
(continued)
The underlining in the variable range column indicates the setting in the preset
mode.
7-2-9 OPTION MODE
Item
Variable
range
Remarks
P.OFF GPS DATA HOLD
CLEAR
For selecting whether or not to hold the
UMID GPS position information while the
power is off and record the information as
the data still held as the previous value until
another measurement can be taken after the
power is next turned on.
HOLD: The data is held and recorded.
CLEAR: The data is cleared at the same
time as the power is turned off, and
all zeros (no information) are
recorded from the time the power is
turned on until the measurement is
next taken.
REC TALLY RED
GREEN
CHAR
For selecting the method to access records
on the unit when the unit is connected to
peripheral devices and used remotely.
RED: The red tally lamp lights.
GREEN: The green tally lamp lights.
CHAR: For displaying “REC” in the
viewfinder.
CUF
CUF
1394 SPEED S200
S400
For setting the transfer rate of signals output
from the DVCPRO connector.
S200:200 Mbps
S400:400 Mbps
CUF
1394 IN CH 0
:
63
AUTO
For setting the input channel of signals input
to the DVCPRO connector.
0 – 63: To fix to the designated value
AUTO: To follow the settings of the
externally connected devices
CUF
1394 OUT CH 0
:
63
AUTO
For setting the input channel of signals
output from the DVCPRO connector.
0 – 63: To fix to the designated value
AUTO: To follow the settings of the
externally connected devices
CUF
1394 CONTROL OFF
BOTH
For setting the control for recording
start/stop operations of external devices that
are connected to the DVCPRO connector.
OFF: Do not control the externally
connected devices.
BOTH: To control both the unit and the
externally connected devices
CUF
1394 CMD SEL REC_P
STOP
For setting the control of recording stop
operations of the external devices that are
connected to the DVCPRO connector.
REC_P: Operation to pause recording
STOP: Stopping operation
CUF
SDI METADATA ON
OFF
For setting metadata (UMID information) to
output to the HD SDI signals.
ON: To output
OFF: Not to output
CUF
SDI EDH ON
OFF
For setting that the detection signals of the
communication error is output to the HD SDI
signals.
ON: To output
OFF: Not to output
CUF