Filter
Top Products
66
5
Press the MENU button to exit the menu operations.
The setting menu is cleared, and the displays showing
the unit’s current statuses appear at the top and bottom
of the viewfinder screen.
<Note>
Data titles cannot be recognized when the setup card
was inserted while the CARD READ/WRITE screen was
open. Move the arrow (cursor) to the TITLE READ item,
and press the JOG dial button.
The data title is recognized, and the title is displayed.
If one of the following messages appears when the JOG dial button is
pressed, the card will not be formatted
Error message
Remedial action
CONFIG NG NO CARD
(setup card has not been inserted)
Insert the card.
CONFIG NG ERROR
(the card cannot be formatted)
The card may be defective.
Replace it.
Saving the data settings on the card
1
Perform the menu operations, and display the “CARD
READ/WRITE” screen.
2
Turn the JOG dial button to move the arrow (cursor) to
the W.SELECT item and press the JOG dial button.
3
Turn the JOG dial button to select a number from 1 to 8,
and press the JOG dial button.
Selecting the file No.
< CARD READ/WRITE >
R.SELECT :1
READ
#
W.SELECT :1
WRITE
CARD CONFIG
TITLE READ
TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
CONFIG NG
WRITE PROTECT
Remove the card to cancel write
protect.
Chapter 4 Adjustments and settings for recording
(continued)
4
Turn the JOG dial button to move the arrow (cursor) to
the “TITLE : ” item.
5
When the JOG dial button is pressed, the arrow (cursor)
moves to the title input area, and the input mode is
established.
7
Press the JOG dial button to enter the character.
8
Turn the JOG dial button to move the arrow (cursor) to
the next position (right), and repeat steps 6 and 7 to set
the characters (maximum of 8).
Giving a title to the selected file
6
Press the JOG dial button again and turn it until the
character to be set is displayed.
When the button is turned, the character displayed is
switched in the following sequence:
Space: ∑
7
letters: A—Z
7
numbers: 0—9
7
symbols: ’, >, <, /, –
< CARD READ/WRITE >
R.SELECT :1
READ
W.SELECT :1
WRITE
CARD CONFIG
TITLE READ
#
TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
< CARD READ/WRITE >
R.SELECT :1
READ
W.SELECT :1
WRITE
CARD CONFIG
TITLE READ
TITLE:
1: ******** 5: ********
2: ******** 6: ********
3: ******** 7: ********
4: ******** 8: ********
;