Filter
Top Products
58
Chapter 4 Adjustments and settings for recording
(continued)
4-8 Selection of video output signals
The unit employs the VIDEO OUT connector and the MON
OUT connector as connectors for outputting video signals.
4-8-1 Settings of signals output from
VIDEO OUT connector
The signal modes for outputting signals from the VIDEO
OUT connector are switched with the VIDEO OUT switch.
HD SDI: To output the HD SDI signals
SD SDI: To output the down-converted SD SDI signals
VBS: To output the down-converted composite video
signals.
The signals output from the VIDEO OUT connector are
switched with the VIDEO OUT OUTPUT SEL switch.
However, the switching operation is not acknowledged
during the recording operation.
VTR: In the recording or other EE mode, camera images
are output from the connector; in playback mode,
the VTR’s playback signals are output.
CAM: The camera images are output at all times.
Item
Variable
range
Remarks
OUTPUT ITEM TC
STATUS
MENU
ONLY
Set the characters to be superimposed on
the output signals from the VIDEO OUT
connector.
TC:
Time codes are superimposed (when the
menu is accessed, the menu screen is
superimposed.)
STATUS:
The characters that are the same as the
characters superimposed in the
viewfinder screen are superimposed.
(When the menu is accessed, the menu
screen is superimposed.)
MENU ONLY:
The menu screen is superimposed only
when the menu is accessed. This
normally displays nothing.
VIDEO OUT OUTPUT SEL switch
Set the characters to be superimposed on the signals output
from the VIDEO OUT connector by using the VIDEO OUT
CHARACTER switch and the OUTPUT ITEM item on the
menu (<OUTPUT SEL> screen on the SYSTEM SETTING
page).
VIDEO OUT CHARACTER switch
VIDEO OUT switch