Filter
Top Products
16
Operating preset memory groups (PMEM GROUP)
The unit allows you register up to four “preset memory groups” created
by selecting one preset memory for each of multiple remote cameras.
Pressing any of the PM GRP 1 to PM GRP 4 buttons simultaneously
recalls all preset memory registered to the corresponding preset
memory group.
The following setting procedures use the example of setting PMEM
GROUP1 but the setting procedures are the same for PMEM GROUP2
to PMEM GROUP4.
Open the following menus and configure the settings.
<Preset memory groups and menu numbers>
Preset memory group Menu
PMEM GROUP1 PM GRP1 menu [31]
PMEM GROUP2 PM GRP2 menu [32]
PMEM GROUP3 PM GRP3 menu [33]
PMEM GROUP4 PM GRP4 menu [34]
Setting the operation mode (SEPARATE/
ALL)
1.
Press the MENU button to turn on its indicator.
2.
Open PM GRP1 menu [31].
1.PM GRP1 MODE
SEPARATE
3.
Turn the F1 dial to display the “1. PM GRP1 MODE” item.
4.
Turn the F2 dial to select the operation mode, and then
press the F2 dial to confirm the selection.
OFF : Disables group creation.
Even if you press any of the PM GRP1 to PM GRP4
buttons, a preset memory group will not be recalled.
SEPARATE : Allows you to create a group by selecting a different
preset number from each remote camera.
Up to ten preset numbers can be registered to one
group.
ALL : Allows you to create a group by selecting the same
preset number from each remote camera.
One preset number for each of all the remote
cameras registered to the unit can be registered to
one group.
Creating preset memory groups
Registering the preset memory to recall when in
SEPARATE mode
1.
Press the MENU button to turn on its indicator.
2.
Open PM GRP1 menu [31].
1.PM GRP1 MODE
SEPARATE
3.
Turn the F1 dial to display the “2. PM GRP1 1/10” item.
2.PM GRP1 1/10
NoAsgn ——————
4.
Turn the F2 dial to set the camera number and preset
number to register to PMEM GROUP1.
If you turn the F2 dial to select the camera number and then press
the F2 dial to confirm the selection, you will then be able to select
the preset number.
Set the preset number in the same way as the camera number.
2.PM GRP1 1/10
CAM001 PRE001
Camera number Preset number
Camera number : Select from NoAsgn and CAM001 to CAM100.
When “NoAsgn” is set, preset memory is not
registered.
Preset number : Select from PRE001 to PRE100.
5.
Turn the F1 dial to display the “3. PM GRP1 2/10” to
“11. PM GRP1 10/10” items.
6.
Register the camera numbers and preset numbers.
zConfigure the settings in the same way as step 4.
zUp to ten preset memory can be registered to one group.
z Do not set the same camera number two or more times for one
preset memory group.
Note