Filter
Top Products
19
Operating tracing memory (TMEM) (continued)
7.
Press START button [11].
The indicator of START button [11] turns on. (Operation wait state)
TM05:
Waiting Opr.
8.
Operate one of the PAN/TILT lever, ZOOM button,
FOCUS dial, IRIS dial, and white balance mode selection
buttons.
The recording of tracing memory starts from the point in time that the
operation began.
zTo record the focus operation and iris operation, press the focus
button and auto iris button to turn off their indicators and then
perform the operations.
TM05:0m02s
Storing.
Recording time
9.
Press STOP button [12].
Recording stops and the tracing memory is saved.
The registered number button turns on and the status returns to that
of step 3.
zWhen the possible recording time elapses, recording stops
automatically.
At that time, operations up until the point in time that recording
stops are recorded.
Recalling tracing memory (RECALL)
1.
Press one of the camera selection buttons
[CAMERA SELECT/GROUP SELECT] to select the
remote camera to be operated.
2.
Press the TMEM button to turn on its indicator.
The tracing memory status appears.
The indicators of number buttons with registered tracing memory
turn on.
CAM1 TMEM
3m50s Remained.
Selected camera number
Remaining possible recording time (max. 5 m 00 s)
z A button with no tracing memory registered does not turn on
even when it is a button with preset memory registered.
Note
3.
Press one of the number buttons that has its indicator
turned on to specify the tracing memory number.
The remote camera moves to the start position.
The indicators of the number button that was pressed and START
button [11] blink. (Recall standby state)
TM03:0m00s
Standby Recall.
4.
Press START button [11].
The tracing memory is recalled and the remote camera starts
moving.
The indicator of START button [11] turns on.
TM03:0m20s
Recalling.
Tracing memory number
Current recall
position
Total time of tracing
memory during recalling
5.
When the recording time elapses, the remote camera
stops automatically.
The number button that was blinking turns on, the indicator of
START button [11] turns off, and the process returns to step 2.
zWhen STOP button [12] is pressed during recalling, recalling stops
and the process returns to step 2.