Filter
Top Products
44
Control interface for external devices (continued)
Registering camera numbers to CAM OUT1 to
CAM OUT10
1.
Press the MENU button.
2.
Open GPI OUT menu [45].
3.
Turn the F1 dial to display the “1. CAM OUT1” item.
1.CAM OUT1
CAM1
4.
Turn the F2 dial to select the camera number to set for
CAM OUT1, and then press the F2 dial to confirm the
selection.
Camera number : Select from CAM1 to CAM100.
5.
Turn the F1 dial to display any of the “2. CAM OUT2”
to “10. CAM OUT10” items and then register a camera
number.
zRepeat steps 3 to 4.
REMOTE
(JST: JEY‑9S‑1A3F(LF)(SN))
You can connect a personal computer or other external device to select
the camera group, select the remote camera, and recall preset memory
or tracing memory.
For further details, contact your dealer.
1 5
6
9
Pin number Signal name
1 ---
2 RXD IN
3 TXD OUT
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 ---
TO PAN/TILT HEAD 1 to 5 connectors
(RJ‑45)
Connect remote cameras with support for a serial connection to these
connectors using LAN cables.
Connect them with straight cables (category 5 or above).
Pin
number
Signal name Description of signal
1 GND Frame ground
2 TALLY Tally output (open collector)
3 TXD – Send data (–)
4 RXD – Receive data (–)
5 RXD+ Receive data (+)
6 TXD+ Send data (+)
7 NC Not used
8 NC Not used
z TALLY (pin number: 2) specifications
Voltage withstand: Max. 24 V DC
Current: Max. 50 mA
LAN connector (RJ‑45)
Connect a remote camera, switcher, or computer that supports an IP
connection to this connector with a LAN cable.
When directly connecting a device to the unit, use a crossover cable
(category 5 or above).
When connecting via a hub (switching hub) or other device, use a
straight cable (category 5 or above).