Filter
Top Products
31
Setting linking with a switcher
Configure the settings for linking the unit with an optional switcher.
To use the function for linking with a switcher, you need to set the
following in advance.
Settings for the connection between unit and switcher
Refer to “Settings for connecting with the remote cameras and
switcher” in Basics (page 29).
Settings on the switcher
The following settings can be configured on the AW-HS50.
z Enabling the function for linking with the unit
Set the “10. CamContLink” item of [13] Operation Menu to “On”.
z Displaying the remote camera names sent by the unit
Set the “4. Name Type” item of [10.1] Input Menu/SDI-IN1
to [10.4] Input Menu/SDI-IN4 or the “2. Name Type” item of
[10.5] Input Menu/DVI-IN to “CAM Name”.
z Displaying icons at the bottom left of the sub screen for
images of the remote camera selected on the unit when the
switcher is outputting images of multi view.
Set “6. Input Status” of [8] MultiView Out/Frame Menu to “On”.
For details, refer to the operating instructions for the switcher.
Registering the camera numbers that will correspond
to the image inputs of the switcher
Refer to the relevant explanation in this section.
Enabling or disabling the function for linking with the
switcher
Refer to the relevant explanation in this section.
Registering the camera numbers that will
correspond to the image inputs of the
switcher
1.
Press the MENU button.
2.
Open SW INPUT menu [43].
3.
Turn the F1 dial to display the input signal of the
switcher to be set.
1.INPUT1
CAM1
Input signal : Select from 1. INPUT1 to 100. INPUT100.
4.
Turn the F2 dial to select the corresponding camera
number, and then press the F2 dial to confirm the
selection.
Enabling or disabling the function for
linking with the switcher
Enable or disable the entire function for linking between the unit and
switcher.
1.
Press the MENU button.
2.
Open SW FUNCTION menu [42].
3.
Turn the F1 dial to display the “1. SWLINK” item.
1.SWLINK
On
4.
Turn the F2 dial to select “On” or “Off”, and then press
the F2 dial to confirm the selection.
On : Enables the function for linking with the switcher.
Off : Disables the function for linking with the switcher.
z Enabling and disabling the link function can be assigned to a USER
button.
Open USER BUTTON menu [35], display one of the “1. USER1”
to “8. USER8” items, and set “SWLINK”.
z When the USER button with “SWLINK” assigned is pressed, the
operation is as follows.
Button indicator on : Enables the function for linking with the
switcher.
Button indicator off : Disables the function for linking with the
switcher.