Filter
Top Products
SETTING UP AND USING THE REMOTE
CONTROL
Setting up the remote control
A battery is installed in the remote control at the time of purchase.
1
Pull out the battery insulation sheet.
œ Once the battery insulation sheet is removed, the
remote control is ready for use.
2
Perform the remote control setting at the digital disk camera (see page 124).
œ The remote control setting must be set properly in order to use the remote control to
operate the digital disk camera.
œ At the time of purchase, the digital disk camera is already set so that the remote control
can be used.
Using the remote control
The remote control must be used within a seven-meter distance from the remote control sensor,
between 15 degrees to the left and right on the horizontal. If there is an obstruction between the
remote control and its remote control sensor, it may block the signal and prevent operation of the
digital disk camera by the remote control. If this is the case, remove the obstruction.
œ Each button on the remote control performs the same operation as the button of the same
name on the digital disk camera (see page 22).
œ When an operation is performed with the remote control, the self-timer lamp lights for one
second to signal that the signal has been received.
œ If the remote control is located to the front and right of the digital disk camera, the digital disk
camera lens may block its signal. If this is the case, change your position.
NOTE
œ The signal range of the remote control may be decreased if used under bright sunlight or
inverted lighting. This is a characteristic of infrared remote controls and not a malfunction. To
reduce problems during use, do not allow such light to enter the remote control sensor.
Battery insulation sheet
Remote control sensor
Self timer lamp
Infrared emitter
7 meters
or less
15˚
15˚
Within
15 degrees
left or right
horizontally
English
36