Filter
Top Products
1-14
DXC-D35/D35WS(UC)
DXC-D35P/D35WSP(CE) V1
Chapter 2 Fitting and Connections
26
Chapter 2 Fitting and Connections
4
Slide the DSR-1/1P and the
camera head together in the
groove as far as possible.
5
Tighten the two screws in the
grip connector and the two
screws in the shoulder pad
section.
Screws
6
Attach the shoulder pad.
To remove the VTR
Reverse the fitting procedure.
To fit a camera adaptor
Follow the same procedure as when fitting a VTR.
Fitting a VTR
Chapter 2 Fitting and Connections
Chapter 2 Fitting and Connections
27
Using the Camcorder Grip
When using the camera head with a VTR as a
camcorder, you can replace the camera head’s grip
with a camcorder grip (not supplied). The type of
camcorder grip and the method for attaching it differ
slightly depending on the type of VTR.
Attaching a camcorder grip to the DSR-1/1P
1
If the viewfinder is attached,
adjust the viewfinder to the
full-forward position.
For details, see “Adjusting the
viewfinder position” on page 32.
2
Remove the camera head
grip’s three screws, then pull
up the grip to remove it.
3
Remove the VTR connection
plate.
4
Remove the DSR-1/1P’s
shoulder strap fitting and the
camera head connection plate.
VTR connection
plate
Camera head
connection plate
Shoulder strap
fitting
(continued)