Filter
Top Products
1-17
DXC-D35/D35WS(UC)
DXC-D35P/D35WSP(CE) V1
Chapter 2 Fitting and Connections
32
Chapter 2 Fitting and Connections
Using the Viewfinder
Removing the Viewfinder
Remove any microphone from the viewfinder before
beginning.
1
Pull the viewfinder connector
out of the VF connector on the
front of the camera head.
2
Loosen the viewfinder left-to-
right position fixing ring, then
pulling up the retaining catch,
slide the viewfinder out.
VF connector
Retaining catch
To fit the viewfinder
Reverse the removal procedure.
Adjusting the viewfinder position
To adjust the viewfinder left-to-right position, loosen
the left-to-right fixing ring, and to adjust the front-to-
back position loosen the front-to-back position locking
catch.
Viewfinger front-to-back
position locking catch
Using Accessories
Viewfinder left-to-right
position fixing ring
Viewfinder left-to-right
position fixing ring
Chapter 2 Fitting and Connections
Chapter 2 Fitting and Connections
33
Left eye adaptor
By fitting a left eye adaptor, you can use the camera
with your left eye to the viewfinder.
Screws removed
from the camera
CAC-12
Fitting an optional microphone
Use the following procedure to attach an optional
ECM-670 Microphone.
1
Loosen the screw of the CAC-
12 Microphone Holder, then
open the holder and replace the
microphone adaptor with the
one supplied with the ECM-
670 Microphone.
2
Insert the microphone in the
microphone holder, close the
holder, and tighten the screw.
Connect the microphone cable
to the MIC IN +48 V
connector.
Microphone adaptor
MIC IN +48 V
connector
Mark
Note
You cannot stow the camera attached with a left eye
adaptor in the LC-421 Carrying Case.
For details, consult your Sony dealer.
Using an Optional Microphone
To use a long microphone such as the optional ECM-
670/672, fit an optional CAC-12 Microphone Holder
to the camera, then mount the microphone in this
holder.
Fitting the optional CAC-12 Microphone
Holder
Remove the two retaining screws (M3 × 8) for the
optional microphone holder, then use these screws to
attach the CAC-12 Microphone Holder.